Automatic Transmission Oil Pans

Amazing product is high quality material and high quality gasket

It's a good quality pan with nice deep heat sinks , I cannot give it a "5" because the factory drilled and tapped hole for your Temp. gauge will only work with an electronic sensor. The hole is too small for a mechanical gauge which is what I am running ( AutoMeter mechanical Temperature gauge ). Fortunately the pan has a substantial boss around the hole allowing me to drill and tap a larger access hole that my mechanical sensor can pass through . I'm also running an AutoMeter psi gauge but that is teed in between my twin Hayden coolers and the factory trans pressure regulator. So the two extra quarts of fluid the B&M pan provides plus the one extra quart from my twin Hayden coolers , when pushing my 600 HP SRT 392 hard I barely hit 200 degrees and that's with a 2800-3000 rpm stall converter . Normal driving around town the tranny stays at about 170 degrees and this is in 90 degree Florida heat . So I am very happy with my pan/cooler setup.