Volvo 960 Washer Tanks & Parts

The item appeared just like the original. However, I couldn't get the little 'barbed' end into the hole in the vehicle frame. I ended up cutting it off. Also, the cap wouldn't snap into place. The inside of the cap seemed a bit smaller than the original. Using a flat-bladed screwdriver, I pushed the top of the plastic filler tube inwards, all around its rim until the cap finally snapped into place. Hopefully, I won't have the same problem when I remove the cap to fill the reservoir. The reason I ordered this part was the original one broke apart. The plastic probably dried out from engine heat. Time will tell if the new cap will do the same.