Vicrez® vz100660 - VZ Style Black Side Skirt Splitters

These look great, even if they were too long for the car. I had to cut them down with a straight edge and jigsaw. Also it only came with 1” self tapping screws. The challengers have a 1” lip on them so there was no way for them to go on the car. I had to make my own brackets which worked well. I had to buy - 12 galvanized L brackets: - 12 5/8” spacers - 12 stainless steel 1-1/2” bolts with rubber nuts - 12 stainless steel 3-4” bolts with rubber nuts Take off the rocker panels. There are two bolts (7mm”) on the front and back. And I believe 6 tabs in the door. Once the rocker is off, evenly measure out 6 spots to drill a 1/4” hole on the 1” lip. Make sure it’s low enough and not too close to the bottom of the body. Cut the L brackets on one side in half, measurements may differ. Make sure to spray the cut areas with galvanized paint to prevent rust. You will have to drill a new 1/4” hole on the L bracket. Make sure when measuring for the L bracket that you’re low enough for the rocker panel to go back on as it does sit lower than the lip. Once you have the L brackets ready. Put them on the lip with the 5/8” spacer separating the L bracket from the lip. Once they’re bolted down you can place your splitter on them and make the measurements to cut them down to size. Once cut place them back on and mark the holes to be pre drilled. I only drilled the hole closest to the middle of the bracket. So the bolt would be hidden by the rocker panel. Once you’re pre drilled just bolt it up. Sorry if my info is a little off. But it worked well for me and it’s holding strong.

Didn't come with any hardware and was sent with instructions for installation on a charger. They don't even have challengers on their YouTube page. The sides aren't rounded like it looks in the pictures, instead theyre squared off and rough. Not worth the buy.

Too long for the car.

They look nice. Haven't put them on yet. I'll update when they are on.