Suspension Air Spring Bag by Suncore®. Air Spring Bag will replace the original Air Spring. Suspension Air Spring Bag failure is usually caused by dry rot, due to old age, or gases in the atmosphere degrade the rubber from the outside. If Air Spring Bags are not replaced on time it will cause Air Suspension Compressor Failure.
Only authorized customers can leave a review on our website. We would love to know what you like or dislike about the product. Share your opinion on product quality, appearance, installation, and other characteristics.
/5
1-10 of 43 Reviews
5 of 5
Range Rover Sport Suspension
Good quality. The only issues that appeared during the installation were related to the the instruction booklet and the diameter of the lower o-rings is 0.38mm too big. Even after removing the paint on the shock absorber they didn't slide down into position. So I went and buy the correct size and profile o-rings. Other than that the suspension is working as intended. The only thing that could be improved is the hardness of the lower flange of the bag.
Posted by Phyllis (Chattanooga, TN) / October 31, 20182003 BMW X5
5 of 5
Chevy Trailblazer SS 2008 Air Bags
Air bags are high quality and very good price. It did take 3 weeks to get them but there was a problem at the factory. I would recommend CARiD to anyone who wants top of the line parts. Very good customer service.
Posted by Neal (Onsted, MI) / October 07, 20182008 Chevy Trailblazer
5 of 5
Air Bag
Air bag is great easy installation. Highly recommend.
Posted by Jacob K (Mount Ulla, NC) / December 16, 20162006 BMW X5
4 of 5
Suspension Air Bag Land Rover lr3
Product was very good and packaged correctly. Only setback was installation was not easy as the kit had to be assembled and then installed in the vehicle. Other than that great product, great packaging and service!
Posted by Terry (Rapid City, SD) / March 01, 20171998 Ford F-250
5 of 5
As Designed With a Small Exception
Almost identical to the OEM. The original (89 Towncar pump) had top mounted bolts. The replacement had peg-legs that went through the 8mm mounting bracket and bolted from underneath which was a little difficult to install due to the location being right on the fender, next to the washer fluid container, and I needed to slightly widen the original holes to make the peg-legs fit. Not too hard to do, but was not expecting it right out of the box. Everything else pugged into the factory harness, and so far worked as planned.