OEM Automotive Tools & Equipment

  • OEM Tools® - Thin Walled Spark Plug Socket
    $20.90
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Oil Funnel
    $21.16
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 8-piece Wheel Hanger Set
    $34.22
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 3/8" Drive 14 mm Standard 12-Point Thin Walled Spark Plug Socket with 12" Extension
  • OEM Tools® - Automotive Tune-Up and Brake Bleed Kit
    $35.88
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 11-piece Disc Brake Tool Set
    $34.44
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Automotive U-Joint Puller
    $82.34
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Harmonic Balancer Installer
    $44.69
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Harmonic Balancer Puller
    $60.13
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 7-piece 24 mm to 38 mm Steel Oil Filter Socket Set
    $28.11
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 3-piece Body Seam Splitter Set
    $51.57
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 2.6 gal Dispenser
    $69.91
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 9-piece Plastic Direct Fit Oil Funnel Set
    $88.22
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Master Tie Rod Tool
    $96.79
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Plastic Direct Fit Oil Funnel
    $21.16
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - MacPherson Strut Spring Compressor
    $45.92
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 3/4" to 3-1/4" Exhaust Tail Pipe Cutter
    $46.94
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - 4-piece O-Ring and Seal Remover Set
    $13.55
    In Stock - Ships in 24 to 48 hrs
  • OEM Tools® - Brake Hub Resurfacing Kit
    $17.92
    In Stock - Ships in 24 to 48 hrs


OEM Tools Reviews

48 reviews
4 of 5
Worked Well Enough.
This support just stretched enough across the rear of the engine to fit my Crown Victoria. The reason for 4 stars is the front bar didn't reach the front of the engine. I had to place a 2X4 across the front of the engine just a little bit past the radiator. It did well hooking up to my engine as well as holding it in place as I swapped the subframe. It would have gotten 5 stars if it was just a few inches longer on both ends.
Posted by Javier (Homestead, FL) / May 22, 20212010 Ford Crown Victoria
OEM Tools