Mitsubishi Outlander Receiver Hitches

Received this in in good order. All things were as described and the installation instructions were not the best but adequate. There was 1 point where they stated you needed to back off a bumper fastener to get it to fit properly. I ignored this part until I realized that I had to back off this fastener about .25" in order for the hitch to fit properly. Another reviewer said she installed it by herself. Good for her, I needed another person to help lift it into position to set the carriage bolts. I could not do both by myself. There was some gaps on the dry fit but the carriage bolts were long enough to span that gap. While tightening it up, it pulled the hitch right to the frame. There are 2 bolts that need to be fished through the frame. However, they did not fit any holes in the frame that were existing. I needed to go to Home Depot to get a steel hole saw bit to open them up. That bit was $17. I want to say it is a 7/8" hole saw. Took about 30 seconds to open each hole and had no issue fishing the bolts through. Threw some paint on the bare metal and away I went. The hardest part for me was removing the exhaust from the 3 rubber mounts. I did not have the right tool to do this but made due with a pair of channel locks that worked out well.