Spark Plug Wire Set by Delphi®. Delphi ignition wire sets provide premium performance in every application because they use OE cable configurations - Delcore, Composite High Temperature or Wire Wound (where applicable) — that are marked for OE component confirmation. Plus, they use OE boots, terminals and lead lengths for hassle-free installation. Installation is also quick and easy thanks to application-correct 7-mm and 8-mm cable sizes that provide a correct fit to harness clips, as well as pre-greased spark plug boots (where applicable).
- Pre-greased spark plug boots for quicker installation
- Delphi packard marked cable - OE component confirmation
- OE boots, terminals and lead lengths - no hassle installation
- Application correct seven and eight millimeter cable sizes - correct fit to harness clips
Delphi Packard Electric Systems produced the first ignition cable in the United States in 1901, and is the world’s leading supplier of electrical and electronic distribution systems and ignition wiring products. This year, 4.6 percent of all vehicles on the road will require a replacement wire set. That’s because ignition cable materials break down over time due to heat and contamination. In fact, the average replacement for wire sets is at 75,000 miles. Failed wire sets contribute to rough idle, misfire under load and poor fuel economy. Using the Delphi’s OE wire sets get vehicles back on the road and back to the performance customers expect.
Delphi® has more than 50 years of OE experience in the fuel handling systems category. Delphi invented the first automotive radiator in 1911, the first car heater in 1929 and the first vehicle air conditioner in 1954. Delphi has over 100 years of experience supplying OEMs, which today includes the likes of Toyota, Ford, Audi and Ferrari.