Acura RSX Seat Brackets & Mounting Hardware

These brackets were a nightmare to install in my RSX. Specifically, the bolt that goes in vertically has very, very little clearance to tighten it down. While I used a socket to remove the original, these rails didn't even have enough clearance to fit either end of my ratcheting wrench. My thinner non-ratcheting wrench fit into the opening, but was so tight against the floor that the side of it was digging into the carpet and extremely difficult to get onto the bolt and turn. And even then, it only had enough space to do a quarter turn each time. Why Spec-D thought this was an acceptable design is beyond me. Also, the mounting tongues are angled out too much, so you have to put the front two in and then push down on the back of the seat to bend them right. Obviously it springs back forward, so you have to put all of your weight on the back of the bracket to get the vertical bolt (that you can barely even touch with your finger tips) threaded into its hole. Really, if you look at the vertical bolt hole on the Sparco mounts, you can see that they're easy to get to with any wrench. So just save yourself a ton of effort and just get Sparco ones instead of these.