2011 Ford F-250 CNC Machined Grilles

I purchased this for my 2016 F250 Superduty King Ranch. It did not look like the picture and had a 90 degree bend at each end. These appeared to be held on by tabs that could be removed so this part could fit multiple vehicles. This could not even be placed in my bumper with these 2 wing extensions. So I broke them off to match the picture. Well then I discovered the part was bent backwards and it had no curved contour to match my bumper. So I tried to send it back but met resistance because I had to break it to get it close to fitting. Also it is attached with adhesive pads and there is no way to get your hand in the area behind the part to firmly press the adhesive pads. It would not secure into place even when I cleaned the area,used adhesive promoter and made ropes to pull the tabs in place. The stainless steel is very thin. This part is a total piece of garbage and I lost $108.