FAQ

Where do I put the weather seal strip?

You will only need to apply the seal strip on top of the bulkhead/tailgate or anywhere you see there is a gap between the truck bed and the cover. You don't really need it if all four sides are sealed and flush.

What should I do if the roll-up cover would not latch properly?

Some adjustment you can do is pull the rails close to the latch as possible, making sure the distance between the latch and rails is not longer than 1/16". Also if the vinyl is too tight or too loose the cover will not latch properly. Therefore, another adjustment you can try is the tension plates on both rails. just make sure both tension plates are on the same scale on both sides. That way you should be able to get the cover latch properly.

Can I have the tri-fold cover folded up during driving?

It's not recommended if you are driving on highways. You can do so on regular roads but just make sure you have the safety clamp secured to the side rails as well.

Can I go to the car wash with the tonneau cover closed?

Automatic car washes with wax treatments are generally not recommended, as the wax can damage the vinyl, and the car wash brushes can damage the thread on the cover. Only the touchless carwash is recommended.
How to buy the correct running board and make sure it will fit?

For the running board, please make sure what is the correct CAB size of your truck. To avoid unnecesary return, also make sure the year and model is the correct one. If you are not sure what is your cab size, please send us a picture of your truck from the side view and Tyger can confirm that for you.

Does the item come with a pair?

Yes, each order comes with a pair for both driver and passenger sides.

Is mounting hardware included in the package?

Yes.

Does this item fit my vehicle?

Please check the fitment section on the listing page.
Why your bull bars claims it will not fit my Ford Ecoboost model?

Unfortunately bull bars block the air intake for the intercooler for Ecoboost trucks, thus affecting the cooling performance. That is why Tyger specify it will not fit.
What should I do if there is gap between the flare and the truck body?

You can loosen the screws first, have someone help push the flare against the truck body to make it snug, then tighten the screws from the top of the wheel well.

How Are Fender Flares Installed?

It is a relatively easy process to install your own fender flares, and the process of installing all four fender flares shouldn't take more than an hour. Check the fit of your new fender flares by laying them against the body of your vehicle. If they fit correctly, the bottom edge will align with the bottom of your vehicle's fender and the front will snuggly fit against the bumper. Note: If your vehicle did not originally have fender flares, you may need to drill holes in the body of your car or truck. Use the template that comes with your fender flare kit and reference your install sheet.

For the pocket style fender flare, the rivets or the bolt that goes to the top of the flare is too short?

The Rivets on the top of the flare is for decoration only, they do not bolt through the truck body. Please do not drill a hole on you truck. Mounting points are under the wheel wells and please follow the instruction thouroghly.
How do I tell whether or not the hitch armor will interfere with my backup sensors?

If your backup sensors are at the same height as your hitch, it may interfere since the hitch step is fairly wide. Since most hitches are under the bumper, it should not affect the sensors.
Is your body side molding the same as the factory molding?

Their body side molding is made of stainless steel with a thickness, which enhances the look of your vehicle, however it's not a replacement part, which is not the same as the factory molding.

How do I remove the pieces from my vehicle?

You can use a heat gun or hair dryer to heat up the pieces and melt the glue. That way you can remove the pieces without damaging the paint.