Spare Tire Mount Bike Rack by Rugged Ridge®. 2 Bikes. Transport up to 2 bikes safely and securely with this spare tire mounted bike carrier. With this handy accessory there's no need to install a receiver to haul your bikes with a hitch mount rack. The Spare Tire Bike Carrier mounts right to your spare tire mounting studs. It's the perfect way to take your bikes everywhere you go with your Jeep. The clamp plate knob is completely lockable to prevent the theft of the bikes from the carrier. CA Prop 65 WARNING - This product contains chemicals known to the State of California to cause cancer, and/or birth defects or other reproductive harm.
Notes: California Proposition 65 Warning.
- Carries up to 2 bikes
- Attaches to spare tire mounting studs
- Easy to install and easy to use
- Bike frame clamp has rubber pads to protect bike's finish
- Includes 2 keys for lockable clamp knob
- Made of 2" powder coated steel tubing
- Fits wheel offsets from 2 5/8" to 6"
- Comes complete with everything required for installation, including instructions
- Backed by a 5-year limited warranty
In the past, with a Jeep you were limited to roof rack (on some models) or hitch mount bike carriers, but now, with the Spare Tire Bike Carrier, you can carry bikes on your rear-mounted spare tire. The Spare Tire Bike Carrier mounts to the same studs your spare tire mounts to, with the included adapter plate. The rest of the carrier attaches to the adapter plate with one bolt, so it can be easily installed when needed and removed and stored when it's not.
This carrier is not only easy to install, it's easy to use. Just remove the clamp plate and lay the frame tubes in the troughs, facing the bikes in opposite directions for clearance. Then install the clamp plate and secure it with the knob. Rubber pads gently grip the bike frames without scratching. Once installed, the clamp knob can be locked with the included key; two keys are provided.
The Spare Tire Bike Carrier is constructed from 2" black powder coated steel tubing for a great appearance and maximum protection against rust. It comes complete with everything required for installation, including instructions, and it's backed by a 5-year limited warranty.
Rugged Ridge® is a division of Omix-Ada, the leader in Jeep replacement parts. Based in Suwanee, Georgia, Rugged Ridge was begun almost two decades ago when the enthusiasts at Omix-Ada decided that even a vehicle as tough as a Jeep could be improved upon. Since then, Rugged Ridge has created over 500 accessories to improve your Jeep’s performance, utility and appearance. Unlike parts made for ordinary vehicles, Rugged Ridge knows that every part made for a Jeep must uphold the Jeep tradition of strength and capability, so every part is designed, tested, manufactured and tested again to make sure it’s perfected. Then and only then can it be installed on your Jeep.