Oxygen Sensor by NTK®. Position: Downstream. Location: B1S2. Thimble type sensors feature a ceramic element that projects into the exhaust system and becomes electrically conductive at high temperature. The sensor element then sends voltage signals back to the engine management system to regulate the air to fuel ratio, for optimum efficiency. All oxygen sensors are platinum coated for durability and are individually tested to guarantee quality.
|O2 Sensor Configuration: Direct Fit|
|Wires Quantity: 4 Wire Leads|
|Installation Type: Screw|
|Wire Harness Length: 42.25" (1073.2 mm)|
|Thread Diameter: 0.71" (18 mm)|
- Increases vehicle fuel economy and engine performance while decreasing vehicle exhaust emissions
- Direct replacement
- Meets OE standards and specifications
- Extensively tested during manufacture to guarantee quality and reliability
- Supplied with a waterproof factory-fitted OE connector for easy installation
- Precision manufactured with a sensing element incorporating NTK's premier technical ceramics
Today, everyone agrees that we have to care about our environment and reduce the amount of pollution produced by vehicles. To encourage reduced emissions, the government has introduced tougher exhaust gas emission legislation. As a result, today modern vehicles are equipped with oxygen sensors that control the fuel and ignition systems to optimize vehicle performance in the areas of fuel economy and emissions. Generally, a vehicle is equipped with two oxygen sensors located before and after the catalytic converter. They check the amount of oxygen in the exhaust and send signals to the vehicle's on-board computer that regulates the air/fuel mixture and monitors catalytic converter function to ensure proper engine performance, optimum mileage, and low emission of air pollutants from the vehicle.
If it happens that your oxygen sensor is failed or worn out, you will experience increased fuel consumption and poor driveability. Moreover, the catalytic converter might be failed. In addition, your four-wheel friend will fail emission test. So, if testing shows your sensor is fault, don't hold on and replace it with this first-class oxygen sensor by NTK designed and manufactured to meet OE requirements for fit, form, and function. The sensor is made of first-grade materials and equipped with waterproof factory fitted connectors to ensure long-lasting durability and perfect fit. It's built with sensing element incorporating exclusive NTK's premier technical ceramics. To guarantee reliability and premium quality, the product is extensively tested during manufacture process.
NGK® was founded in 1936 as a subsidiary of NGK Spark Plug Co, Ltd., of Japan. Since its foundation, it has designed and manufactured the products where they are going to be used. It means a substantial number of products sold in the USA are made in America. One of the benefits of such a policy is the ability to work closely with manufacturers in developing products tailored specifically to their needs. Constantly researching new ways to reduce emissions, improve fuel mileage and engine efficiency, the company developed additional product lines such as NTK®, NTK Knock Sensors, and a variety of other sensors. All products are OE approved and built with the highest quality materials and craftsmanship to ensure superior quality and durability.