One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty applies only to the original purchaser of this product from an authorized iSimple Solutions’ dealer. This warranty covers any supplied or manufactured parts of this product that, upon inspection by iSimple Solutions’ authorized personnel, is found to have failed in normal use due to defects in material or workmanship. Attempts to service or modify this product, operating under conditions other than the recommended voltage, will render this warranty void.
Unless otherwise prescribed by law, iSimple Solutions shall not be liable for any personal injury, property damage and/or any incidental or consequential damages of any kind (including water damage), resulting from malfunctions, defects, misuse, improper installation, or alteration of this product. All parts of this iSimple Solutions’ product are guaranteed for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above, iSimple Solutions will repair or replace the product at their discretion, if it is defective in material or workmanship, providing it is returned to an authorized iSimple Solutions’ dealer, with proof of purchase from an authorized iSimple Solutions’ dealer.
This equipment may be reset by unintentional electrostatic discharge during operation. Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that which the receiver is connected to.
4. Consult the dealer or an experienced radio/television technical for help.
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
FCC ID: XBD-PXAMGBT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.