All JBA headers and exhaust products are guaranteed, to the original purchaser, to be free of defects in materials and workmanship for one year. This warranty covers the replacement or repair of the product only and does not cover the cost of removal and installation, customer applied aftermarket coatings or any discoloration or corrosion of finished surfaces.
Damage or product failure resulting from collision, improper installation, off-road use, road hazards, the use of exhaust insulating wrap or like products or rust occurring after installation, is not covered by the warranty. The warranty extends only to the original purchaser.
Should a part become defective it should be returned to the original selling retailer and must be accompanied with the sales receipt. If there is no retailer in your area, call the factory for a return authorization and return your part prepaid to the factory for inspection. PerTronix reserves the rights to replace or repair the alleged defective part and return the part freight collect.
Certain uses or occurrences listed below will void this warranty.
PURCHASER ASSUMES RESPONSIBILITY: JBA expressly disclaims, and the purchaser expressly assumes, responsibility for all labor related costs and any incidental or consequential damages arising from any JBA product installation or failure. JBAs liability is limited to the purchase price of the product. JBA, at its option, may refund the amount of the purchase to end a warranty claim. Labor charges incurred to install or remove the product are not covered. Damage resulting from incorrect timing, fuel system problems, clogged catalytic converters or backfire is not covered. Charges for the loss of use of vehicle, car rentals, and towing are the responsibility of the customer and are not covered. Cost of customer- applied coatings is not covered. As sound preference is subjective, sound is not warranted. Other than the warranty described herein, JBA products are sold AS IS. No warranty terms are implied. The terms of this warranty are severable. Any provision voided by state or other applicable law shall not act to enlarge other provisions of this warranty except as expressly required by law. Catalytic converters and other products sold but not manufactured by JBA are subject to the product manufacturers warranty only and are not warranted by JBA.
JBA reserves the right to change the price, design, material, or specifications of any product without notice.
THE FOLLOWING WILL VOID THIS WARRANTY: Use of heat-wrap products and/or the use of fuels other than gasoline will void this warranty. Damage caused by improper installation is not covered under this warranty. Damage caused by collision, road hazards, or failure of other components is not covered. Any repair or alteration to a JBA product not performed by JBA or its authorized agents will void this warranty.
NO FREIGHT WARRANTY: JBA does not warrant freight. The purchaser will be responsible for freight to and from JBA. Contact JBA to make a warranty claim and to receive a return authorization number. Return the product freight prepaid along with a copy of the original purchase invoice and a written description of the problem including the return authorization number to the address below. JBA does not accept freight-collect shipments. A product found to be defective or otherwise covered under this warranty will be repaired or replaced per the above policy and returned freight-collect.
JBA cannot assume responsibility for compliance with local law and regulations regarding smog and noise standards. Headers described as smog legal are warranted to be C.A.R.B. (California Air Resources Board) exempt or pending exemption approval. This warranty is extended solely to the original purchaser and for the original vehicle on which the product was installed.