Jeep Wrangler 1987-1995, Push Bar by Rugged Ridge®. Add some protection to the front of your Jeep without replacing the bumper. This bold, rugged looking Bumper Guard is designed to bolt to your factory bumper. It's made of heavy-duty steel and powder coated in gloss black.
- Provides additional front end protection
- Rugged design enhances appearance
- Bolts on to existing bumper
- No drilling required
- Constructed from heavy-duty steel
- Powder coated for durability with gloss black finish
- Includes mounting hardware and detailed instructions
- Backed by a 5-year limited warranty
Get added front end protection and rugged good looks on a budget with this Bumper Guard. The Bumper Guard bolts on to your factory bumper and looks so good no one will be able to tell your Jeep didn't come that way. The Bumper Guard is made of 3/8" steel side plates and 2.5" tubular crossmembers. It takes only a few minutes to bolt the Bumper Guard to your factory bumper with the included hardware. No drilling or modifications to your bumper are required. The Bumper Guard is powder coated for exceptional appearance and long term durability, in gloss black. The Bumper Guard is backed by a 5-year limited warranty.
Rugged Ridge® is a division of Omix-Ada, the leader in Jeep replacement parts. Based in Suwanee, Georgia, Rugged Ridge was begun almost two decades ago when the enthusiasts at Omix-Ada decided that even a vehicle as tough as a Jeep could be improved upon. Since then, Rugged Ridge has created over 500 accessories to improve your Jeep’s performance, utility and appearance. Unlike parts made for ordinary vehicles, Rugged Ridge knows that every part made for a Jeep must uphold the Jeep tradition of strength and capability, so every part is designed, tested, manufactured and tested again to make sure it’s perfected. Then and only then can it be installed on your Jeep.