JKS® - Triple Chrome Plated Bodyside Molding

Buick Enclave 2008-2012, Triple Chrome Plated Bodyside Molding. Add styling detail and protection to the sides of your vehicle with these chrome bodyside moldings. The chrome will add sparkle and gleam to catch the eye, and the tough, automotive-grade ABS plastic will protect your doors from parking lot dings and shopping cart dents. They install easily with 3M™ automotive-grade, double-sided tape, so you'll be getting complements on your car's new look in very little time.

Features:

• Made from rugged, automotive-grade ABS plastic
• Triple chrome plated for maximum luster
• Custom designed for each application
• Comes pre-measured and cut, and ready to install
• Installs easily with 3M™ automotive-grade, double-sided tape
• Made in U.S.A.

Brighten your vehicle and accentuate its lines by placing these chrome moldings along body lines. Or position them on flat smooth areas to interrupt a plain expanse and add styling detail. If you drive a base model vehicle, adding these chrome moldings will make your car look like a deluxe model. Regardless of why or where you install them, these moldings will make your car or truck more pleasing to the eye. And once installed, they’ll be in position to absorb parking lot dings and dents, instead of your doors.

These bodyside moldings are made from rugged, automotive-grade ABS plastic and triple chrome plated for a deep, long-lasting shine. Unlike most other body moldings, that use a vacuum metalizing or spray-on chrome-look process, these moldings receive a genuine, multi-stage chroming process. The real chrome on these moldings is 3 layers thick and much more scratch resistant; however the chrome will crack if the molding is bent. Therefore all triple chrome plated ABS plastic moldings are shipped in protective tubes with labels exclaiming: Do Not Bend.

There’s no need for any cutting or drilling to install your bodyside moldings. They’re pre-cut and install with 3M™ automotive-grade, double-sided tape. Determine where you want the molding, peel back the cover from the tape, and press the molding into place.