1999 Nissan Pathfinder Fenders
REPLACEŽ - Front Inner Fenders, Rear Section of LinerNissan Pathfinder 1999, Front Inner Fenders, Rear Section of Liner by ReplaceŽ. Fenders can suffer from collision damage, rust, and dings and dents from stones and shopping carts. At the extreme such damage may make your vehicle undriveable or at...Our price: $17.14$17.14 20% OFF
REPLACEŽ - Front FendersNissan Pathfinder 1999, Front Fenders by ReplaceŽ. Fenders can suffer from collision damage, rust, and dings and dents from stones and shopping carts. At the extreme such damage may make your vehicle undriveable or at the very least unsightly. A...Our price: $60.00 - $166.62$60.00 20% OFF
REPLACEŽ - Fender LinersNissan Pathfinder 1999, Fender Liners by ReplaceŽ. Front Section of Liner. Inner Fender Liners keep road debris from inside the engine compartment. These usually unseen panels can be damaged in a front end collision, but they're also susceptible...Our price: $17.14$17.14 20% OFF
REPLACEŽ - Front Fender FlaresNissan Pathfinder 1999, Front Fender Flares by ReplaceŽ. Fender Flares are exaggerated wheel well moldings that add emphasis to the wheelhouse. They are often used to accent wide wheels and tires. They're one of the first casualties in a fender...Our price: $94.28 - $133.70$94.28 20% OFF
"Flares were well packaged, everything included, great directions for simple installation (and reading the instructions on these is well worth the time)."
Aaron C. - 1986 Jeep CJ (Bloomingdale, NJ)
"Heavy duty thick material, not a cheap plastic design as I have seen from other manufacturers. These should hold up well in the future and down the road. Thanks CARID."
Jimmy A. - 2000 Jeep Wrangler (Dearborn, MI)
"I had to purchase new flares because I hit a deer, and the originals were damaged. They cover my Wildcat AT tires really well! They work great too. All in all, they're built well, but they fade a little (second Buffalo winter), and cane get scratched by brush on the trail."
Brian L. A. - 1986 Jeep CJ (Glendale, AZ)
"Fit was great and covered my 33x12.50's perfectly. I recommend buying the hardware kit. I did not and spent some time at the part store looking for the right bolt, fender washer, and fasteners to replace the rusted factory hardware."
Stewart E. - 1986 Jeep CJ (Cornwall, ON)
"These flares look great and cover my 35" x 12.5" tires just perfectly. I did have to trim the small lower front flares. I just used some metal shears and trimmed to fit. If you don't do that, the small flares will push on the middle of the fender flare, because the small flare is factory size (not 7") and is too long to fit right. For a pretty simple modification, I decided it wasn't worth knocking the review down to 4 stars."
Troy M. - 1998 Jeep Wrangler (Charlotte, NC)


(7)