SAA® - Rocker Panel Trim "U-Type"

Dodge Neon 1995-1998, SAA Rocker Panel Trim "U-Type". Bring style to your car with SAA rocker panel trim that looks like chrome. Made of high-quality mirror polished stainless steel. Easy stick-and-go installation.

Features:

• Gives your vehicle a distinct look.
• Adds protection against minor dents and scratches.
• Uses 3M adhesive for easy installation.
• Will stay on for the life of the vehicle when installed according to the included instructions.
• Made from high quality stainless steel with smooth mirror polished finish that looks like chrome.
• Made in USA.

Image: The diagram illustrates the type and placement of each rocker panel trim offered by SAA:

• I - Molding Insert (Either goes over existing trim if any or sticks directly onto the car if no trim exists)
• L - Lower Kit (Is measured from the bottom of the doors up a specified width).
• O - On Rocker Kit (Applies directly onto rocker).
• U - Upper Kit (Is measured from the bottom of the molding down a specified width).

Customize your vehicle trim with nifty rocker panel molding kit by SAA. This brightly polished, high gloss trim looks and feels like chrome, and adds a touch of elegance to your car. It’s crafted of high-quality stainless steel that will not rust or corrode. Moreover, the SAA trim kit protects your paint-job from minor scratches and dents caused by road debris. The rocker panel trim is installed along the bottom of the doors. It uses high-quality 3M acrylic adhesive for effortless installation. You don’t need to drill or screw to put your new rocker panel trim in place - simply seal it on according to instructions and drive with style!